Arduino Rain Sensor

[Graeme1858]

I put an Arduino Rain Sensor for the observatory together earlier in the year. But when the weather heated up I dropped it and worked on an extractor fan controller instead. Well it's not hot any more and there's risk of rain every day instead! So I've resurrected the Rain Sensor project and improved on the mark 1 with the addition of an anti condensation heater to stop dew forming on the rain sensor plate.

So the Arduino measures the voltage between alternate lines on a Vero board using a voltage divider, when a rain drop falls on the Vero board the voltage on an analogue input pin changes. I used an Ascom driver I found online to tell NINA the Safety Monitor state change from Safe to Not Safe. Then using the NINA Ground Station plugin, NINA sends a notification to an app called Pushover. Pushover then sends a notification to my phone to wake me up if I've nodded off on the settee!

A DHT11 sensor measures temperature and humidity. The Arduino code calculates the dew point and when it rises to < 4 below ambient temperature a relay switches on a supply to a pair of heating power resistors to prevent dew forming on the rain sensor and giving a false alarm.

The whole thing works really well, on my desk! I've yet to put it in the observatory. There's just one minor flaw, there is no heater feedback loop, once the humidity rises and the heaters come on, they stay on. I think I need to put the heaters in a box under the rain sensor and use another DHT11 to provide additional control of the heaters.

This is it so far:

Can anyone think of a problem that hasn't occurred to me? Yeah, I know the rain sensor plate soldering is rough! It had been a while when I did that. The final version will be neater. And yeah I know the cable feeding the secondary side of the relay contacts is too small, the final installation cable sizes will be fit for purpose!

Graeme

[TerryMcK]

Is this now installed and working Graeme? If so have you worked out the bits to put into the NINA sequence?
I'm making one using a NANO and an Hydreon RG-9 based upon a thread in CN https://www.cloudynights.com/topic/7927 ... ina-64bit/ but am struggling with the NINA safety monitor and loop conditions.

[KathyNS]

I don't understand why the heater would stay on. Surely once the temperature-dewpoint spread increases again, the Arduino would switch off the heater? I do much the same thing with my skycam dew heater. In 'automatic' mode, it turns on the heater when the spread is less than 2 degrees (C) and turns it off when it is more than 2 degrees. It is necessary to keep the sensor away from the heater so it is responding to ambient air temperature rather than device temperature.

Your rain sensor is a "wet leaf" type. It is very effective for detecting moisture, but might be too effective. You have the advantage of doing the analog-digital conversion yourself, so perhaps you can calibrate it better than mine. I used a commercial wet-leaf unit (sold by Lee Valley for detecting water heater leaks) which had a simple on/off relay output. Unfortunately, it would trigger on the slightest dew, aborting a perfectly fine photo session unnecessarily. I replaced it with a Hydreon RG-11 rain sensor, which, on the second-most-sensitive setting, gives very sensitive rain detection without triggering on dew.