Problems connecting ETX-90 to Stellarium
-
- Articles: 0
- Posts: 3
- Joined: Sun Jun 21, 2020 6:44 pm
- 3
- Location: Indiana
- Status:
Offline
Problems connecting ETX-90 to Stellarium
The cable I ordered was a RJ11-to-Serial but an RJ11-to-USB came in the mail so to find the correct drivers I had to open the usb and found an FT232R(https://www.ftdichip.com/Products/ICs/FT232R.htm), so I downloaded the drivers(https://www.ftdichip.com/Drivers/VCP.htm) for that chipset.
My next problem was when I tried to control the telescope using Stellarium and these are my settings:
Telescope Controlled By: Stellarium, directly through a serial port
Connection delay:1.50s
Coordinate System: J2000
Serial Port: /dev/cu.usbserial-AD0JLHUX -- [If I select /dev/tty.usbserial-AD0JLHUX I get a permanent loading cursor]
Device model: Meade ETX70 (#494 Autostar, #506 CCS) -- [I actually use a #497 Autostar but I hope that isn't a problem]
Is there something I am doing wrong? Any help is appreciated.
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute