Page 2 of 2
Re: CGX-L keeps hitting switch limits!?
Posted: Sun Apr 24, 2022 1:42 pm
by UlteriorModem
Last night after updating the firmware on the
HC and motor controller I gave it another try, same error.
I guess it is time to install and learn the CPWI interface
Re: CGX-L keeps hitting switch limits!?
Posted: Thu Apr 28, 2022 10:03 pm
by UlteriorModem
So another bit happier update...
I got and installed the CPWI software and happy to report it works quite well! Solved my side of pier issue and sequence went start to finish with no issues, including flips and target change / aquisition.
But now I cannot figure out how to get it to 'park' at the end of the sequence.