I have now owned my 18"
Today I cleaned the mirror using this modified method. I tipped the fully assembled scope to a low altitude so that the open rear of the mirror box cleared the rocker box exposing the mirror. I passed a 6x4 foot poly tarp through the side so that it was under the now almost vertical mirror. I also placed a thin sheet of. perspex under the tarp so that water draining off the mirror would just drain out the back and not pool in pockets formed by the weight of the water.
What you will need:
One clean spray bottle - mix about 5 - 10 drops detergent into 500ml water
3 old dishwashing detergent bottles that were rinsed very thoroughly .
- one with tap water
- one with rain water,
- one with demin water.
You can skip the rain water and just use demin. If I had more demin, I would have done that. Living out in the country far from pollution and acid rains, rain water is very clean.
1. I mixed some dilute dishwashing detergent into a spray bottle and sprayed the mirror surface thoroughly until soapy water was draining down te surface onto the tarp. I checked the drainage and made sure it was draining and not running into the rocker box. Working well
2. Next squirt tap water to rinse off the soapy water
3. repeat steps 1&2
4. squirt rinse with rain water
5. squirt rinse with demin water twice
6. Leave the scope so the mirror can drain to beads of water then use the edge of a piece of dry kitchen absorbent towel to wick up the remaining droplets.
The result is pretty good with much of the dust and dirt gone. A thin hazy adhered grime remains. I should have applied a gentle swish of a piece of kitchen towel soaked in soapy water to dislodge the most adhered grime from the mirror but I forgot. Today is very Now that i know how easy this is, I will "rinse and repeat" again very soon but add a gentle mechanical swish wash action to the surface to dislodge the most stubborn layer of grime.
My friend Phill @scribbly is here for 3 day stay. We washed his 10 inch ultra light ultra portable
Using much the same method, we washed his mirror. In this case, I did give his mirror a gentle mechanical wash with a soapy kitchen towel which dislodged the hazy surface grime and left a beautiful clean finish.
My hands were both full and wet and I didn't take any photos. I will set up an intervalometer and photograph the process next time I repeat this process, hopefully soon, to include a gentle mechanical wash to remove the hazy grime.
My rocker box is all constructed from marine ply so a bit of water won't harm the mechanical structure. However, the 10000 step shaft encoders for the NEXUS navigation system is down there and I didn't want any water ingress to the encoder circuits or mechanics.
Joe